52 lines
1.5 KiB
Plaintext
52 lines
1.5 KiB
Plaintext
|
;
|
||
|
|
; Linux Telephony Interface
|
||
|
|
;
|
||
|
|
; Configuration file
|
||
|
|
;
|
||
|
|
[interfaces]
|
||
|
|
;
|
||
|
|
; Select a mode, either the phone jack provides dialtone, reads digits,
|
||
|
|
; then starts PBX with the given extension (dialtone mode), or
|
||
|
|
; immediately provides the PBX without reading any digits or providing
|
||
|
|
; any dialtone (this is the immediate mode, the default). Also, you
|
||
|
|
; can set the mode to "fxo" if you have a linejack to make it operate
|
||
|
|
; properly. If you are using a Sigma Designs board you may set this to
|
||
|
|
; "sig".
|
||
|
|
;
|
||
|
|
mode=immediate
|
||
|
|
;mode=dialtone
|
||
|
|
;mode=fxo
|
||
|
|
;mode=sig
|
||
|
|
;
|
||
|
|
; You can decide which format to use by default, "g723.1", "g729", or "slinear".
|
||
|
|
; Note that g729 is only supported for Sigma Designs boards.
|
||
|
|
; XXX Be careful, sometimes the card causes kernel panics when running
|
||
|
|
; in signed linear mode for some reason... XXX
|
||
|
|
;
|
||
|
|
format=slinear
|
||
|
|
;format=g723.1
|
||
|
|
;format=g729
|
||
|
|
;
|
||
|
|
; And set the echo cancellation to "off", "low", "medium", and "high".
|
||
|
|
; This is not supported on all phones.
|
||
|
|
;
|
||
|
|
echocancel=medium
|
||
|
|
;
|
||
|
|
; You can optionally use VAD/CNG silence suppression
|
||
|
|
;
|
||
|
|
;silencesupression=yes
|
||
|
|
;
|
||
|
|
; List all devices we can use. Contexts may also be specified
|
||
|
|
;
|
||
|
|
;context=local
|
||
|
|
;
|
||
|
|
; You can set txgain and rxgain for each device in the same way as context.
|
||
|
|
; If you want to change default gain value (1.0 =~ 100%) for device, simple
|
||
|
|
; add txgain or rxgain line before device line. But remember, if you change
|
||
|
|
; volume all cards listed below will be affected by these values. You can
|
||
|
|
; use float values (1.0, 0.5, 2.0) or percentage values (100%, 150%, 50%).
|
||
|
|
;
|
||
|
|
;txgain=100%
|
||
|
|
;rxgain=1.0
|
||
|
|
;device => /dev/phone0
|